A dynamic measurement of a disc chipper cutting forces

Abstract : Nowadays wood chips produced from raw material of inferior quality are mainly used to feed domestic and industrial boilers. For this use, a good chip size distribution and low manufacturing energy consumption are required. Cutting forces are still inaccurately measured during the wood chipping process, which implies the use of oversized chippers' motors. A test bench for chipping wood under reasonably realistic conditions of industrial production is improved by adding an indirect force measurement system with high bandwidth of 3 KHz. The dynamic experimentations give the data needed to compute the curve presenting the vertical component of the cutting force, which is composed of three sections; the first one presents the values of the impact force; the second one is relatively straight and it refers to shear stress in wood; the third section corresponds to the period between two crosscuts.
Type de document :
Article dans une revue
Biomass and Bioenergy, Elsevier, 2014, 64, pp.269-275. 〈10.1016/j.biombioe.2014.02.033〉
Liste complète des métadonnées

https://hal.univ-lorraine.fr/hal-01597080
Contributeur : Lermab Ul <>
Soumis le : jeudi 28 septembre 2017 - 10:41:05
Dernière modification le : mardi 24 avril 2018 - 13:40:02

Identifiants

Collections

Citation

Rami Abdallah, Sébastien Auchet, Pierre Jean Meausoone. A dynamic measurement of a disc chipper cutting forces. Biomass and Bioenergy, Elsevier, 2014, 64, pp.269-275. 〈10.1016/j.biombioe.2014.02.033〉. 〈hal-01597080〉

Partager

Métriques

Consultations de la notice

17