This deliverable describes the implementation into reality of the framework of a replicable Open Manufacturing Demonstration Facility supporting the INEDIT process. The introduction presents the internal validation process developed during the project and how the consortium managed to open to the communities to validate its demonstrator (section 1.1). Initially, this validation is done "part by part" through specialists, scientific publications and by focusing on specific technological developments with different TRL levels. Then, the whole process and its contributions will be progressively validated and disseminated to a wider audience. This first section also depicts the system and its technologies supporting the DIT approach. In other words, the report explains what the demonstrator should be (section 1.2). The second section details the evaluation and the adaptations made to the INEDIT OMD. This part describes the regular evaluation of the OMDFs’ development over a long period of time (almost 2 years) and provides the status of each OMDF and its digital environment at the end of INEDIT project, in February 2023 (sub-section 2.1). Then we analyse the monitoring for each part of the OMD. We will not explain the 1420 lines, we take a few emblematic examples to give an overview (sub-section 2.2). Finally, the sub-section 2.3 studies the design modalities of the DesignTogether platform, a multimodal interfaces and multi-platform (web app, AR mobile app, VR app) supporting the DIT process. This supplementary work, needed to carry out the evaluation and adaptation of OMD, focuses on the realization of an original UX design protocol allowing to design and evaluate by use this potential “multi-sided” platform. To conclude this report provides experience feedback on the monitoring and the adaptation of the OMD (section 3).